Carburettor and supplies

One set of mounting screw for the intake pipe carburettor.
Fit to all BVF carburettors 28HB..

• contens: 1x screws, 1x secure washer
• one piece will be needed

Repeirset for Trabant carburettor typ 28 HB 1-...
Fit to all carburettors up to vintage: july 1984.
Set consist of:

• 1x Sgauge needle valve (LDM-part.-no.:742)
• 3x nozzle (50, 115, 125), 1x CO-bolt with sealing ring (LDM-part.-no.:744)
• 1x float (LDM-part.-no.:740)
• 1x carburettor lid seal (LDM-part.-no.:735)
• 2x Sealing carburettor-flange (LDM-part.-no.:732)

Self-repair-set for carburettor-type 28 HB 1-...
fit to all carburettors up to vintage: july 1984.
set consist of:

• 1x gauge needle valve
• 3x nozzle (50, 115, 125)
• 1x CO-bolt with sealing ring

Fiber sealing ring for sealing the bolt of the idler jet (LD45) and the air inlet nozzle (SD120).
Fit to some types of the carburettor 28HB.
This sealing rings are made for the exact fitting and sealing of this components.
data:

• material: fiber sheated plastic
• inner diameter: 6 mm
• outer diameter: 9 mm
• thickness: 1,0mm
• two pieces will be needed

Idler jet (LD45)fit to all types of the carburettor 28HB up tp type 28HB 3-1.

• material: brass
• made in Germany
• one pieces will be needed

The air inlet nozzle (SD120) fit to all types of the carburettor 28HB.

• material: brass
• made in Germany
• one pieces will be needed

Fiber sealing ring for the main jet sealing bolt carburettor type 28HB.
Fit to the type with spanner gap: SW14
data:

• material: fiber sheated plastic
• inner diameter: 11 mm
• outer diameter: 15 mm
• thickness: 1,0mm
• one piece will be needed

Holder for main jet of the Trabant BVF carburettor type HB 1-.
This type is with spanner gap SW14 and threat M11.

• delivery as single part
• without jet and without sealing
• material: brass
• threat: M10x1
• threat for nozzle: M5
• one piece will be needed

Fiber sealing ring for the main jet sealing bolt carburettor type 28HB.
Fit to the type with spanner gap: SW13
data:

• material: fiber sheated plastic
• inner diameter: 10 mm
• outer diameter: 14 mm
• thickness: 1,0mm
• one piece will be needed

Holder for main jet of the Trabant BVF carburettor type HB 1-.
This type is with spanner gap SW13 and threat M10.

• delivery as single part
• without jet and without sealing
• material: brass
• threat: M10x1
• one piece will be needed