Brake pipes for Trabant

This brake pipe connect the both wheelbrake cylinder rihgt hand inside the brake drum direct at the brake base plate.

• complete bordered
• with screw-cap for brakeline 4.75 x 0,7
• one piece will be needed
• length of the brake tube line 300mm
• diameter 4,75 x 0.7mm

This brake pipe connect the both wheelbrake cylinder left hand inside the brake drum direct at the brake base plate.

• complete bordered
• with screw-cap for brakeline 4.75 x 0,7
• one piece will be needed
• length of the brake tube line 300mm
• diameter 4,75 x 0.7mm

flexible front brake hose connection between Inner front brake line right hand or Inner front brake line left hand and Outer front brake line right hand or Outer front brake line left hand
Fit to Trabant 500,600 and 601 with type of Simplex and Duplex brake sytem.

• high quality product
• new reproduction made in EU
• one piece for each wheel brake side

short brake hose with female and male thread connection
suitable for rear brake of Trabant 601 and some trailer types

• thread: M10 x 1
• length complete: 18 cm
• two pieces will be needed
• maed in Europe

Rear short brake hose with female and male thread connection. Made by the german producer ATE.
Suitable for the rear brake of Trabant 601 all models (with coil or leaf spring) and some trailer types

• high quality, made by ATE
• thread: M10 x 1
• length complete: 18 cm
• two pieces will be needed

sacer spring for connection between flexible brake hose and brake pipe
not the same design like the originale one (made for VW). This retainer can be also used for Trabant and Wartburg.

• electrogalvanized, black
• high quality made in Germany, spring metal
• one piece for each screw joint will be needed

sacer spring for connection between flexible brake hose and brake pipe

• surface bronzing
• one piece for each screw joint will be needed