spare parts for the engine compartment Trabant 601

Pin for connection between adjusting bolt engine bonnet and alu joint for engine bonnet.

• two pieces will be needed

Pin made of stainless steel for connection between adjusting bolt engine bonnet and alu joint for engine bonnet.

• Material: VA, stainless steel
• two pieces will be needed

The cylinder-head screw, slotted M3 x 6 have to be mounted at the alu joint for engine bonnet to fix the steel pin.

• two pieces will be needed

Aluminium hinge for joint engine bonnet.
Delivery as singel part, without any mounting bits.
New reproduction.

ring eye bolt connection between alu joint for engine bonnet and bonnet reinforcement.
Reproducion made in Germany

• Material: steel, galvaniced
• two pieces will be needed

Hexagon bolt for mounting the engine bonnet joint at the car body (water drain)

• delivery inclusive washer
• two pieces will be needed
• galvaniced

rubber grommet for flexible speedometer shaft
fit to all variants of Trabant 601 and 1.1

• inner diameter: 7,5 mm
• for hole diameter of: 25 mm
• thickness: 7,5 mm
• one piece will be needed

Membrane plug made of black rubber (Polychloropren) to shut round holes in car bodys (such as service holes) or as variable cable grommet seal for some wires (also with plugs)

fit to hole diameter of 25 mm
inner diameter of membrane (max. usable diameter): 18,5 mm
outer diameter (total): 30,5 mm
thickness: 7 mm

Membrane plug made of black rubber (Polychloropren) to shut round holes in car bodys (such as service holes) or as variable cable grommet seal for some wires (also with plugs)

fit to hole diameter of 20,5 mm
inner diameter of membrane (max. usable diameter): 13,5 mm
outer diameter (total): 25 mm
thickness: 7 mm

Membrane plug made of black rubber to shut round holes in car bodys (such as service holes) or as variable cable grommet seal for some wires (also with plugs)

fit to hole diameter of 37 mm
inner diameter of membrane (max. usable diameter): 29 mm
outer diameter (total): 44 mm