fuel system

6-part jet set for the carburettor BVF 40F of Wartburg 353, B1000.
Called Berliner-carburettor 40F
Delivery inclusive gauge needle valve and Mixture screw BVF 40F.

• Material: brass / rubber
• one set will be needed
• made in Germany / EU

Screw for fix the butterfly valve at the throttle shaft.
Fit for the Berlin carburettor BVF 40F.
Please note: this screw have to be mounted properly, use Threadlocking - medium strength (Art.-Nr.:6380).
Lose screws can cause worse engine damages!

• Raised countersunk-head screw
• delivery as single part
• total: 2 pieces will be needed

Pessure spring for the aditional accelerator pump of the carburettor type BVF 40F. Fit for Wartburg 353 and B1000.
For dismounting and mounting is it necessitating to split the carurettor case.
Exact mounting place: please click on Detail

• Reproduction made in Germany
• surface: galvaniced
• one piece will be needed

Nut and secure washer for fix the tappet of the accelerating pump.
Fit for the Berlin carburettor BVF 40F.
For dismounting and mounting is it necessitating to split the carurettor case.
Exact mounting place: please click on Detail

• scope of delivery: 1x nut and 1x spring washer
• total: one pieces will be needed

Connection hose for the idle system of the carburettor type BVF 40F called Berliner Carburettor
Fit to Wartburg 353, B1000.

• Delivery inclusive two hose clamps
• Made in Germany
• one kit will be needed

Torsion spring for the starter flap shaft.
Fit for the Berlin carburettor BVF 40F.
For assembly it is necessary to dismantle the choke flap.
Please note: this screw have to be mounted properly, use Threadlocking - medium strength (Art.-Nr.:6380).
Lose screws can cause worse engine damages!

• Spring made of stainless steel
• delivery as single part
• total: 1 piece will be needed

Outside torsion spring for the starter flap shaft.
Fit for the Berlin carburettor BVF 40F.
For assembly it is necessary to dismantle the choke flap.
Please note: this screw have to be mounted properly, use Threadlocking - medium strength (Art.-Nr.:6380).
Lose screws can cause worse engine damages!

• Spring made of stainless steel
• delivery as single part
• total: 1 piece will be needed

Torsion spring for the throttle flap shaft.
Fit for the Berlin carburettor BVF 40F.
For assembly it is necessary to dismantle the screwing of thr throttle flap.
Please note: this screw have to be mounted properly, use Threadlocking - medium strength (Art.-Nr.:6380).
Lose screws can cause worse engine damages!

• Spring made of stainless steel
• delivery as single part
• total: 1 piece will be needed

Throttle control cable for the carburettors type BVF 40F for Wartburg.
Machanical connection between accelerator and throttle valve of the carburettor.

• total length: 105 cm
• length of the bowdencabe cover: 81 cm
• one piece will be needed
• made Germany