Trabant 500/600

The product category IFA-vehicles > Trabant 500/600 is spread over 10 sites:

Windscreen washer kit 6V Detail Set for windscreen washer system with electrical pump and water bottle voltage: 6V Scope of delivery: bottle 1,5 liter cap metal holder wash pump 6V Ideal for upgrate the mechanical hand pump into an electrical system.

56,53 €inclusive VAT, plus shipping costs temporary not available Art.No. 7597

Electronic ignition base plate for 6V, complete Detail Retrofitting kit for 6V ignition system of 2-stroke Trabant variants to change from contact breaker system to electronic system. All mechanical parts will not changed. The centrifugal advance mechanismn will left, too. So the change of ignition timing during low revs will work also after retrofitting. Special made for 6V system Trabant 500,600 and 601 Advantage: no mechanical contact breakers (no maintenance work for lubricating and readjusting) Simplified adjusting of ignition timing for cylinder 2 through automatic adoption of cylinder 2 timing If necessary the old contact breake ignition plate can be put back later An additional wire for power supply of ignition system is to install from ignition coil (+6V, terminal 15) to base plate.

159,50 €inclusive VAT, plus shipping costs temporary not available Art.No. 7536

Brush for starter Detail Spare-brushes of the starter engine to solder on at the coil set. Can be used for all kind of starters 6V and 12V left- and right turning (without Trabant 1.1, Wartburg 1.3 and Baraks B1000-1) mounting place: brushholder bas plate size: 16X19x7 delivery as an single part for each starter two pieces will needed
original spare part number: 8202.11-220:10	8,24 €inclusive VAT, plus shipping costs Delivery in 1-3 days Art.No. 785

Spring for brush starter Detail Pressure spring for the brushes of the starter engine. This spring will push the brush at the collector ring from the rotor shaft. Can be used for all kind of starters 6V and 12V left- and right turning (without Trabant 1.1, Wartburg 1.3 and Barkas B1000-1) mounting place: brushholder bas plate original spare part delivery as an single part for each starter two pieces will needed

original spare part number: 8202.11-220.6

1,55 €inclusive VAT, plus shipping costs Delivery in 1-3 days Art.No. 7629

Bolt for starter Detail Bolt of the Bearing case of the starter engine. Connection bolt will be mounted at the beraing case threadholes and on the other side it will hold the rear case cover. Delivery as a single part without nuts an washers. Can be used for all kind of starters 6V and 12V left- and right turning (without Trabant 1.1, Wartburg 1.3 and Barkas B1000-1) original spare part surface: galvaniced total length: 16.5 cm delivery as an single part for each starter two pieces will needed

original spare part number: 8202.1-000:4/1

2,93 €inclusive VAT, plus shipping costs Delivery in 1-3 days Art.No. 7658

Battery 6V 84Ah, dry ( not charched ) Detail Batterie for cars with 6V supply voltage. The capacity is 84 Ah. The starting power is 240A. We just deliver this battery dry and uncharched. Design fit to historical vehicles. length: 22,5 cm wide: 17,5 cm highness case: 20 cm total highness inclusive pins: 22 cm made in Germany
+7,50 Euro deposit	225,50 €inclusive VAT, plus shipping costs Delivery in 1-3 days Art.No. 1225

Plug for body Detail Small plug for holes diameter 5mm. Can be used for the car body. material: rubber, black total length: 27mm made in Germany

2,81 €inclusive VAT, plus shipping costs Delivery in 1-3 days Art.No. 7705

Rubber sleeve cushion for shock absorber 30mm Detail The bushing is pressed in to the eye of the shock absorber diameter size 30mm. Fit to Trabant 500,600,601 leaf spring shocks or Wartburg 311/312/353, DDR trailers shocks and so on... 1x length inner sleeve: 32 mm 1x rubber made in Germany 2 or 4 pieces will be needed

12,90 €inclusive VAT, plus shipping costs Delivery in 1-3 days Art.No. 8028

Electric fuel cock Detail Electical petrol valve (shut off vale) of the Trabant 601. Easy to install beween the fuel hose form the petrol tank to the carburettor. fit to all Trabant 500, 600 and 601 types power: 12V maximum reduction of the permanet leaking of the craburettors at stand one piece will be needed delivery inclusive electrical connecting cable

45,32 €inclusive VAT, plus shipping costs Delivery in 1-3 days Art.No. 8217