Front axle

Nut for the connection ball joint for the other wishbone and and the swivel bearing. Fit to all Wartburg 312, 353 und 1,3 models. The nut can be used for the upper and the bottom wishbone.

• delivery inclusive spring washer
• four pieces will be needed

Connection ball joint as a single part for repairing of the front axle (other wishbone and and the swivel bearing).
Fit to all Wartburg 312, 353 und 1,3 models. The joint is mounted at the upper and the bottom wishbone.
This part is an high quality reproduction made in Europe.

• fit to Wartburg 312, 353 and 1.3 modells like Limousine, Tourist, Camping and Trans
• delivery inclusive sealing cap
• for each wheel side two pieces will be needed, total four pieces for each car

10x Mounting screw for ball joint (Art.-Nr.:7774)
2x Mounting nut for ball joint (Art.-Nr.:7716)
2x Locking plate for ball joint for wishbone (Art.-Nr.:7003)

Hexagon bolt for the connection ball joint and upper and lower wishbone, front axle left and right hand.
Fit to all Wartburg 312, 353 und 1,3 models. The nut can be used for the upper and the bottom wishbone.

• material grade: 10.9
• delivery inclusive spring washer
• 10 pieces will be needed

Replacement sleeve for ball joint of wishbones fit to all types of Wartburg 353 and 1.3.
Please note: only use for Reproducted ball joints. Does not for for originale ones!!!

• one piece needed for each ball joint (2 pieces for each front axle side)
• material: rubber
• made in EU

Locking plate for both outer mounting screws of ball joint for the other wishbone and and the swivel bearing. fit to all Wartburg 312, 353 und 1,3 models.
The joint is mounted at the upper and the bottom wishbone.

• for each ball joint one piece will be needed