brake system

Complete in Germany overhauled rear wheel brake cylinder with ring sleeves, brak-piston D=15,87mm.
Mark: RENAK BZ 105
Fit to Trabant 601 from 1.4.1968 onwards.

• scope of delivery: inclusive ring sleeves and bleeder screw
• break piston diameter: 15,87mm
• also used for some IFA-vehicles, Camptourist tent trailer
• two pieces will be needed

also for Camptourist tent trailer
Please note, we can only exchange you this spare part if you ship 1x wheel brake cylinder with the mark Renak BZ 105 to our company in advance!

Complete in Germany overhauled rear wheel brake cylinder with ring sleeves, brak-piston D=19,04mm.
Fit to Trabant 601 up to 03.1968 and Trabant 1,1 all models.

• scope of delivery: inclusive ring sleeves and bleeder screw
• break piston diameter: 19,04mm
• also used for some IFA-vehicles, Camptourist tent trailer
• two pieces will be needed

Complete rear wheel brake cylinder with ring sleeves and brak-piston D=15,87mm.
Reproducition spare part as low budget product.
Fit to Trabant 601 from 1.4.1968 onwards.

• scope of delivery: inclusive ring sleeves, without bleeder screw
• break piston diameter: 15,87mm
• also used for some IFA-vehicles, Camptourist tent trailer
• two pieces will be needed

also for Camptourist tent trailer

complete rear wheel brake cylinder with ring sleeves, brak-piston D=15,87mm.
Fit to Trabant 601 from 1.4.1968 onwards.

• scope of delivery: inclusive ring sleeves, without bleeder screw
• break piston diameter: 15,87mm
• also used for some IFA-vehicles, Camptourist tent trailer
• made in EU
• two pieces will be needed

also for Camptourist tent trailer

Brake cylinder for the rear wheel brake sytem of the Trabant 500, 600 and 601 (with vintage definition)
Reproduction with high quality.

• made in Italy
• complete pre-assembled with rubber sealings
• bore diameter 19,05 mm
• fit to Trabant up to vintage 31.3.1968
• fit to the rear axle left and right hand
• fit also for the camper Qek
• delivery without bleeder screw
• two pieces will be needed

additional needed bits, not part of this offer. Please order separately:
2x LDM-part.no.:7532 mounting screw for wheel brake cylinder
LDM-part.no.:214 bleeder screw for wheel brake cylinder
LDM-part.Nr.:215 dust cap for bleeder screw

special tools for disassembly / assembly:

• no special tools needed to install the wheel brake cylinder at the Trabant or Qek brake plate