Ignition system Trabant 601

Electronic ingnition base plate ignition sensor for the battery ignition system of the Trabant.

• delivery inclusive with magnetic ring and sensor, but without towing arm
  
• original spare part

Radial roller bearing for the main shaft of the electronic ingnition base plate ignition sensor for the battery ignition system of the Trabant.
Delivery as an both side covered bearing type:2RS.

• made by FAG
• two pieces will be needed

Magnatic ring for the electronic ingnition base plate.
Can be ussed for the battery ignition system of the Trabant.

• delivery as an single part with out any mounting parts
• original spare part

Electronic ingnition base plate ignition sensor for the battery ignition system of the Trabant.

Retrofitting kit for 6V ignition system of 2-stroke Trabant variants to change from contact breaker system to electronic system.
All mechanical parts will not changed. The centrifugal advance mechanismn will left, too. So the change of ignition timing during low revs will work also after retrofitting.
Special made for 6V system Trabant 500,600 and 601

Advantage:

• no mechanical contact breakers (no maintenance work for lubricating and readjusting)
• Simplified adjusting of ignition timing for cylinder 2 through automatic adoption of cylinder 2 timing
• If necessary the old contact breake ignition plate can be put back later

An additional wire for power supply of ignition system is to install from ignition coil (+6V, terminal 15) to base plate.

Retrofitting kit for 12V ignition system of 2-stroke Trabant variants to change from contact breaker system to electronic system.
All mechanical parts will not changed. The centrifugal advance mechanismn will left, too. So the change of ignition timing during low revs will work also after retrofitting.
Advantage:

• no mechanical contact breakers (no maintenance work for lubricating and readjusting)
• Simplified adjusting of ignition timing for cylinder 2 through automatic adoption of cylinder 2 timing
• If necessary the old contact breake ignition plate can be put back later

An additional wire for power supply of ignition system is to install from ignition coil (+12V, terminal 15) to base plate.

Cable harness for the electronic base palte (green ignition board and black sensor ring).
The wires are complete inclusive the additional ignition +6V/12V (terminal 15).

• fit to the offered 6V and 12V elektronical ignition boards
• made in Germany
• easy to install