Rear brake parts

For this spare part we use only the case of the brake cylinders from latest fabrication. The pistions will be special made and we replace the ring sleeves into original ones made in Germany.
So we can offer you an product by best quality.

• delivery complete with german sealings
• brake pistion diameter 19,05 mm
• Trabant 601 up to vintage: 31.3.1968, for Trabant 500, 600, 601 Baujahr
• also for QEK-caravan with hydraulic brake system
• inclusive bleeder screw

Rear wheel brake cylinder for Trabant 1,1.
Brake-piston D=19,05mm.
Complete with sleeve, without bleeder screw
made in Europe

Ring sleeve for wheel brake cylinder D=19,05mm
2 pieces in one set.
Fit to Trabant 500,600 und 601 up to 31.3.1968 and all Trabant 1.1
The ring sleeve should only be changed, if inner surface of cylinder is okay.
Otherwise the complete wheel brake cylinder part no.: 212 should be changed.

Bleeder screw for rear wheel brake cylinder Rear wheel-brake cylinder piston = 19,05mm and Rear wheel-brake cylinder piston = 15,87mm Trabant 601, Trabant 1.1 and QEK-caravans.
The bleeder screw fit also to Brake suddle left hand and Brake suddle right hand Wartburg 353 and Wartburg 1,3.
3 pieces will be needed for each brake suddle.

thread: M8 X 1,25

fit to all offered bleeder screws
Protect the bleeder screw hole from dust and water.

• material: rubber
• made in Germany

The pressure web is fixed between the two rear wheel brake shoes to transmit the power of the mechanical handbrake to both of the brake shoes.

• material: metal, galvaniced
• place: rear wheel brake, left hand
• original spare part
• fit to Trabant 601 and Trabant 1,1
• one piece will be needed

The pressure web is fixed between the two rear wheel brake shoes to transmit the power of the mechanical handbrake to both of the brake shoes.

• material: metal, galvaniced
• place: rear wheel brake, right hand
• original spare part
• fit to Trabant 601 and Trabant 1,1
• one piece will be needed